EvoGRIP™ Surf Grip Pads

Give your front foot a dedicated grip zone with EvoGRIP™ Surf Grip Pads. This three-piece TPU set sits on the deck around your lead-foot stance area, with separate left, middle and right strips you can space to suit your board and preferred foot placement.

Flowing organic outlines and a wave-patterned grip surface create a distinctive, low-profile setup. Designed for front-foot placement, rather than as a rear tail pad.

Tough, flexible TPU construction

Built from wear- and tear-resistant TPU for riders who want a durable alternative to EVA foam. In our hands-on comparisons, our TPU was far more resistant to tearing and breakdown than the EVA pads we tested. A tough, flexible construction is at the heart of the EvoGRIP design.

Traction in wet and oily conditions: In our EvoGRIP testing, the textured surface retained traction when wet or oily.

Three-piece set dimensions

• Left strip: 12 inches long × approximately 3.91 inches at its widest point (304.8 × 99.2 mm).
• Middle strip: 12 inches long × approximately 3.94 inches at its widest point (304.8 × 100 mm).
• Right strip: 12 inches long × approximately 3.91 inches at its widest point (304.8 × 99.2 mm).

Widths vary along the organic contours. Each set includes all three strips. Space them closer together for a compact layout or farther apart for a wider footprint; wider spacing leaves more exposed deck between the strips.

Placement

Dry-fit all three pieces before attaching them. Position the set where your front foot naturally lands and moves, then adjust the spacing to suit your stance. Prepare a clean, dry, wax-free surface and follow the adhesive's installation instructions for your board's deck finish.

Also intended for compatible e-foil and strapless kiteboarding decks, and other water-board applications where the foot is not held in a binding. Check deck fit, foot placement and attachment suitability for your setup before use.