Sticky Feet
EvoPad™ Standard Width Set - Front & Rear Bundle w/ Integrated Studded Grip
EvoPad™ Standard Width Set - Front & Rear Bundle w/ Integrated Studded Grip
Couldn't load pickup availability

Available Colors (in order above): Black, White, Gray, Grape, Lime, Blue, Light Blue, Red, Pink, Gold, Orange, Teal
* Front Pad sensor is Dual Zone and includes 5-pin (GT & Pint) or 6-pin (XR) connector - everything you need to plug and play.
* Pad Widths: GT ("9.8"), +XR ("9.5"), Pint (9.8"). Credit to Matixbuilt as the Pint Pad design is a remix of his original model.
EvoPad™ is the next evolution in footpad design—engineered from a single piece of ultra-durable TPU for unmatched strength, comfort, and performance. Featuring an embedded studded TPU grip surface, EvoPad™ eliminates the need for traditional grip tape and the hassle of constant replacements. Its soft-yet-grippy texture provides superior control and comfort on every ride. The front pad includes a fully integrated sensor, permanently sealed within the pad itself, making it virtually indestructible and weatherproof. Designed to last, EvoPad™ delivers a cleaner look, a better feel, and the ultimate in reliability for serious riders.
Share
1 week later and the rivnuts have already pulled out of the pads. Huge bubble in the center from the start of the install. Tried adjusting to remove the bubble but no luck. Do not buy.
Hi Jesse, sorry to hear you haven’t been loving your EvoPad experience. Regarding the bubble you mentioned, the top sheet of the pad is actually designed to float separately from the lower layers, and that movement is essential to how the pad and internal sensor work together for proper engagement. As for the heat-set inserts, that can happen occasionally because we use soft TPU for the pads. The fix is pretty simple: remove the pad, apply E6000 around the perimeter of the insert, then press the insert back into place. Once the adhesive cures, it should create a permanent bond.
Only one complaint thus far.
One of the studs (nutserts) pulled out.
I was using new screws and I DON’T use Loctite!
I have had nutserts pull out of a FM foot pad so I now use antiseize on all screws that use nutserts.
I did NOT over tighten the screw.
I also heard from another rider at Dirtsurferz about this issue.
I am STILL very happy with my Stickyfeet footpads.
I used E6000 adhesive to re-insert the nutserts.
I just want to make you aware of the issue.
I plan to also order a set of NOTORIOUS footpads and I hope I do not have the same issue.
I know nutserts in plastic and rubber can cause issues so I take great care with them.
Thank you,
Mark Fortune
I emailed and they prioritized my order! The product is 10/10
Footpads are great the light blue matches perfectly. Fhe grip is also very nice. The communication with sticky feet is amazing to!!
